I want to have produced a small molded assembly ( 1 in x 1 in) that has one moving part. Think of the assembly as a flag with a rod at one end (first molded piece) where both ends of the rod are over molded such that the over mold is like a sleeve. The objective is that, after over molding, the flag/rod piece can still rotate inside the sleeve. Said another way, the over mold does NOT adhere to the rod/flag.

Think of this like one half of a saloon door where the door rod is INSIDE the wall rather than mounted on the side with a hinge. The post molding gap between the flag and sleeve needs to be less than ~1mm.

Is it possible to build such an assembly? I'm an electrical engineer and need to ascertain whether such a structure is possible before I move to the next phase of the design.

Thanks

Scott